Plastic Pipe Fittings

ABS tee fitting for 1.25-inch pipes with cement connection.

PVC equal tee for 63mm pipes to branch flow in three directions.

PVC threaded fitting for 3/4-inch pipes.

EPDM rubber gasket for sealing 80mm pipe flanges.

Push-fit plastic elbow for connecting 1/4-inch tubes.

Push-fit adapter for connecting 15mm pipes to water taps.

PVC cap to seal off the end of 20mm pipes.

Push-fit CPVC equal tee connector for 15mm pipes in plumbing systems.

PVC cap fitting to close 25mm pipes at the end of plumbing runs.

ABS threaded adapter connecting two 3/4 inch pipe sections together.

PVC 45-degree elbow bend for changing pipe direction on 1-inch lines.

Push-fit CPVC adapter connecting 22mm pipes to tap water outlets.

CPVC 90-degree elbow for right-angle pipe turns on 20mm lines.

PVC threaded adapter joining two 1/2 inch pipe sections with threading.

EPDM rubber gasket seal for 1-inch pipe flange connections.

PVC reducer bush stepping down from 1.5 inch to 3/4 inch pipes.

PVC threaded nipple connecting two 1.25 inch threaded pipe sections.

PVC reducer bush stepping down from 2 inch to 1.25 inch pipes.

CPVC 90-degree tee connector for 40mm pipes in plumbing networks.

Push-fit slip tee junction for 22mm pipes in water distribution.