Black flexible cable chain with tight bend radius for compact cable routing in precision machinery systems.
Grey PVC sleeve bend for pipes with short radius and extended length.
Yellow PVC sleeve bend for gas pipes with custom radius and length specifications.
Gray PVC sleeve bend for extending pipe runs through walls and structures.
Yellow PVC sleeve bend 63mm for gas pipe conduit installation.
Blue PVC sleeve bend 160mm large diameter for drainage conduit.
Green PVC sleeve bend 50mm for cable television conduit routing.
Green PVC sleeve bend 50mm for long-run cable television installation.
Compact fire-resistant cable chain for tight-radius bending in industrial machinery.
Black flexible cable chain with tight bend radius for dense cable routing in compact machinery spaces.
PVC transit bend for routing utility pipes through floors and walls.
Double 87.5-degree PVC bend for drainage, 40mm grey fitting.
Flexible black polymer cable chain for tight-radius machinery with flame protection.
Yellow PVC pipe sleeve bend for gas line drainage and utility penetration solutions.
Hydraulic pipe bender for bending half-inch tubes and pipes to various angles.
Red bent conduit pipe protects electrical wires in shorter wall runs.
Bent plastic pipe conduit protects water pipes through walls and floors.
Orange PVC transit bend sleeve for running utility lines through building foundations and walls.
Black plastic 87.5-degree bend for 125mm drainage pipe connections.
PVC drainage bend for changing pipe direction at 15-degree angle.
PVC drainage bend for 45-degree pipe routing in indoor drainage systems.
Gray PVC transit bend sleeve for running utility lines through building foundations and walls.
Pre-galvanised 90-degree bend for medium-duty cable tray runs.
Stainless steel light duty 90-degree bend for small cable trays.
Black plastic 30-degree bend for 50mm drainage pipe connections.
Black plastic 45-degree bend for 75mm drainage pipe connections.
Stainless steel 90-degree bend accessory for changing cable tray direction in cleanroom and corrosive areas.
Floor-mounted press brake for bending sheet metal up to 14 gauge mild steel.
Heavy-duty 90° corner bend for medium industrial cable trays with galvanised finish.
Heavy-duty 90° corner bend for large industrial cable trays with galvanised protection.
Light-duty corner bend for smaller cable trays in low-load electrical installations.
Floor-mounted press brake for bending sheet metal plates in fabrication workshops.
Three-in-one machine for shearing, bending, and rolling 20 gauge mild steel sheets, 40 inch capacity.
Black plastic sharp angle bend for tight drainage pipe connections and turns.
Extra flexible PVC conduit allowing tight radius bends for compact electrical cable routing.
Black flexible e-chain cable for machinery with tight bending requirements.
Black cable chain with tight bend radius for protecting cables in highly dynamic equipment.
45-degree PVC bend for angling 70mm rainwater drainage lines.
Steel inspection bend fitting for 20mm electrical conduit installations.
45-degree PVC bend for 100mm rainwater drainage piping.