20-amp DC solid state relay for surface-mount panel installation in machinery control.
A red LED pilot light that mounts flush into a 30mm hole on control panels to show when equipment is running or in an alarm state.
A white LED indicator light that mounts flush into a 22mm panel opening, rated IP65 for dusty or damp environments, powered by 24V AC or DC.
A red LED indicator light that mounts flush on control panels to show equipment status or alarm conditions, operating on low DC voltage.
A green LED pilot light that mounts flush into a 30mm hole on control panels to show when equipment is running or a circuit is live, powered by AC voltage.
An orange LED indicator light that mounts flush in a 30mm hole on control panels and machinery to show operational status or warnings, rated for 195-264V AC power.
Honeywell industrial toggle switch for on-off control in electrical panels.
Dual-pole monitoring relay for chassis mounting in control cabinets.
Surface-mounted six-pole isolator switch, 20A and 13kW rated, sealed IP65.
Screw-mounted relay for direct panel installation in industrial equipment.
Three-pole 63A surface-mounted isolator switch for industrial equipment control.
Two-contact front-mounted auxiliary block for industrial electrical control systems.
Surface-mounted three-phase isolator for flexible electrical installation positioning.
120V AC relay module for panel mounting in North American industrial systems.
Two-contact normally closed auxiliary block for side mounting on contactors.
A red LED indicator light that mounts on control panels to show when equipment is running or in alarm, rated for 230-240V AC power.
Panel mounted manual reset thermostat for industrial heating systems to 150 degrees.
Eaton two-contact side-mounted auxiliary switch for industrial control circuits.
Panel-mount three-phase isolator switch rated 32A, 15kW, IP65 protection.
A yellow LED indicator light that mounts on control panels to show machine status or alarms, rated for 230V power.
A red LED indicator light that mounts on control panels to show equipment status or alarm conditions, powered by 12V electricity.
Bushing-mounted toggle switch with screw connections for panels.
Side mounted auxiliary contact with mixed contact configuration for control.
A red LED indicator light that mounts flush on control panels to signal equipment status or alarms, with waterproof protection suitable for wet environments.
Siemens two-contact side-mounted auxiliary switch for automated control systems.
A white LED indicator light that mounts on control panels to show equipment status, rated for wet and dusty environments.
Flush-mounted 32A isolator switch with neutral pole for industrial electrical safety.
A clear indicator light that mounts on control panels to show when equipment is running or powered on, rated for 250 volts.
A white LED indicator light that mounts on control panel doors and cabinets to show equipment status or power on/off conditions.
A small green LED light that mounts on control panels to show when equipment is running or powered on, works on 24V power.
A red LED indicator light that mounts directly into control panel holes to show when equipment is running or in alarm.
A red LED indicator light that mounts on control panels to show when a machine or alarm is active, powered by standard 230V electricity.
A green LED indicator light that mounts on control panels to show when equipment is running, rated for wet environments and powered by 110V AC electricity.
A red LED indicator light that mounts on control panels to show machine status or alarm conditions, sealed against dust and light water spray.