A red LED indicator light that mounts flush on control panels to show equipment status or alarm conditions, operating on low DC voltage.

Small white polycarbonate enclosure kit for mounting electrical terminals and control components on DIN rails.

A green LED pilot light that mounts flush into a 30mm hole on control panels to show when equipment is running or a circuit is live, powered by AC voltage.

An orange LED indicator light that mounts flush in a 30mm hole on control panels and machinery to show operational status or warnings, rated for 195-264V AC power.

Honeywell industrial toggle switch for on-off control in electrical panels.

Dual-pole monitoring relay for chassis mounting in control cabinets.

Surface-mounted six-pole isolator switch, 20A and 13kW rated, sealed IP65.

Screw-mounted relay for direct panel installation in industrial equipment.

Three-pole 63A surface-mounted isolator switch for industrial equipment control.

Two-contact front-mounted auxiliary block for industrial electrical control systems.

Surface-mounted three-phase isolator for flexible electrical installation positioning.

WEG side-mounted terminal block with mixed contacts for contactor control circuits.

120V AC relay module for panel mounting in North American industrial systems.

Two-contact normally closed auxiliary block for side mounting on contactors.

A red LED indicator light that mounts on control panels to show when equipment is running or in alarm, rated for 230-240V AC power.

Panel mounted manual reset thermostat for industrial heating systems to 150 degrees.

Eaton two-contact side-mounted auxiliary switch for industrial control circuits.

Panel-mount three-phase isolator switch rated 32A, 15kW, IP65 protection.

A yellow LED indicator light that mounts on control panels to show machine status or alarms, rated for 230V power.

A red LED indicator light that mounts on control panels to show equipment status or alarm conditions, powered by 12V electricity.

Bushing-mounted toggle switch with screw connections for panels.

Side mounted auxiliary contact with mixed contact configuration for control.

A red LED indicator light that mounts flush on control panels to signal equipment status or alarms, with waterproof protection suitable for wet environments.

Siemens two-contact side-mounted auxiliary switch for automated control systems.

A white LED indicator light that mounts on control panels to show equipment status, rated for wet and dusty environments.

Flush-mounted 32A isolator switch with neutral pole for industrial electrical safety.

A clear indicator light that mounts on control panels to show when equipment is running or powered on, rated for 250 volts.

A small green LED light that mounts on control panels to show when equipment is running or powered on, works on 24V power.

A white LED indicator light that mounts on control panel doors and cabinets to show equipment status or power on/off conditions.

A red LED indicator light that mounts directly into control panel holes to show when equipment is running or in alarm.

A red LED indicator light that mounts on control panels to show when a machine or alarm is active, powered by standard 230V electricity.

A green LED indicator light that mounts on control panels to show when equipment is running, rated for wet environments and powered by 110V AC electricity.

A red LED indicator light that mounts on control panels to show machine status or alarm conditions, sealed against dust and light water spray.

A red LED indicator light that mounts on control panels to show equipment status, running at 24 volts.