ESD-safe forming plier for precise wire shaping and bending tasks.
ESD-safe forming pliers for shaping and bending fine wire and components.
Anti-static forming pliers for bending wire and sheet in electronics assembly.
Grey PVC sleeve bend for pipes with short radius and extended length.
Yellow PVC sleeve bend for gas pipes with custom radius and length specifications.
Gray PVC sleeve bend for extending pipe runs through walls and structures.
Yellow PVC sleeve bend 63mm for gas pipe conduit installation.
ESD-safe forming pliers for bending and shaping soft wires in assembly work.
Blue PVC sleeve bend 160mm large diameter for drainage conduit.
Green PVC sleeve bend 50mm for cable television conduit routing.
Anti-static bending pliers for electronic component assembly and wire forming.
ESD-safe forming pliers for bending and shaping wire in electronics assembly.
Green PVC sleeve bend 50mm for long-run cable television installation.
PVC transit bend for routing utility pipes through floors and walls.
Double 87.5-degree PVC bend for drainage, 40mm grey fitting.
ESD-safe forming pliers for bending and shaping wires and light materials.
ESD-safe forming pliers with wider jaw for bending and shaping work.
Yellow PVC pipe sleeve bend for gas line drainage and utility penetration solutions.
Manual form bender for creating consistent bends in flat bar and strap metal.
Curved pincers for bending and forming medium-hard wire in mechanical and electrical work.
Hydraulic pipe bender for bending half-inch tubes and pipes to various angles.
Red bent conduit pipe protects electrical wires in shorter wall runs.
Bent plastic pipe conduit protects water pipes through walls and floors.
ESD-safe forming pliers for precise wire shaping in static-sensitive environments.
Orange PVC transit bend sleeve for running utility lines through building foundations and walls.
Black plastic 87.5-degree bend for 125mm drainage pipe connections.
PVC drainage bend for changing pipe direction at 15-degree angle.
PVC drainage bend for 45-degree pipe routing in indoor drainage systems.
Gray PVC transit bend sleeve for running utility lines through building foundations and walls.
Pre-galvanised 90-degree bend for medium-duty cable tray runs.
Stainless steel light duty 90-degree bend for small cable trays.
Black plastic 30-degree bend for 50mm drainage pipe connections.
Black plastic 45-degree bend for 75mm drainage pipe connections.
Stainless steel 90-degree bend accessory for changing cable tray direction in cleanroom and corrosive areas.
Floor-mounted press brake for bending sheet metal up to 14 gauge mild steel.
Heavy-duty 90° corner bend for medium industrial cable trays with galvanised finish.
Heavy-duty 90° corner bend for large industrial cable trays with galvanised protection.
Larger anti-static forming pliers for shaping and bending heavier components.
Light-duty corner bend for smaller cable trays in low-load electrical installations.
ESD-safe forming plier for shaping and bending wire without damage.