Double 87.5-degree PVC bend for drainage, 40mm grey fitting.
Grey PVC sleeve bend for pipes with short radius and extended length.
Yellow PVC sleeve bend for gas pipes with custom radius and length specifications.
Gray PVC sleeve bend for extending pipe runs through walls and structures.
Gray PVC drainage bend for solvent welding indoor water pipe systems.
Yellow PVC sleeve bend 63mm for gas pipe conduit installation.
Blue PVC sleeve bend 160mm large diameter for drainage conduit.
Green PVC sleeve bend 50mm for cable television conduit routing.
Green PVC sleeve bend 50mm for long-run cable television installation.
PVC transit bend for routing utility pipes through floors and walls.
Yellow PVC pipe sleeve bend for gas line drainage and utility penetration solutions.
PVC double bend fitting for indoor drainage and water supply piping systems.
Hydraulic pipe bender for bending half-inch tubes and pipes to various angles.
Red bent conduit pipe protects electrical wires in shorter wall runs.
Bent plastic pipe conduit protects water pipes through walls and floors.
Grey electrical connector block that mounts on DIN rail for safely wiring multiple circuits in control panels and machinery.
Orange PVC transit bend sleeve for running utility lines through building foundations and walls.
Industrial double-level terminal block for connecting wires in control panels and electrical systems, rated for 2.5mm² cables at 24 amps.
Black plastic 87.5-degree bend for 125mm drainage pipe connections.
PVC drainage bend for changing pipe direction at 15-degree angle.
A brown double-stacked electrical connector for hazardous areas, designed to safely connect thick wires in extreme temperatures.
PVC drainage bend for 45-degree pipe routing in indoor drainage systems.
Gray PVC transit bend sleeve for running utility lines through building foundations and walls.
Pre-galvanised 90-degree bend for medium-duty cable tray runs.
Stainless steel light duty 90-degree bend for small cable trays.
Black plastic 30-degree bend for 50mm drainage pipe connections.
A modern white double electrical outlet with built-in safety grounding for safe home and office use.
Black plastic 45-degree bend for 75mm drainage pipe connections.
Stainless steel 90-degree bend accessory for changing cable tray direction in cleanroom and corrosive areas.
Floor-mounted press brake for bending sheet metal up to 14 gauge mild steel.
Heavy-duty 90° corner bend for medium industrial cable trays with galvanised finish.
Heavy-duty 90° corner bend for large industrial cable trays with galvanised protection.
Light-duty corner bend for smaller cable trays in low-load electrical installations.
Grey electrical connector block for industrial panels that stacks two connection levels on standard DIN rail.
Floor-mounted press brake for bending sheet metal plates in fabrication workshops.
A two-tier electrical connector block that screws onto DIN rail in control panels, safely joining wires up to 4mm thickness at 30 amps.
Three-in-one machine for shearing, bending, and rolling 20 gauge mild steel sheets, 40 inch capacity.
Industrial screw-type electrical connector block that mounts on standard rails for safely connecting wires in control cabinets and machinery.
A blue two-tier electrical terminal block that screws onto DIN rails in control panels to connect multiple wires safely and reliably.
An orange, safety-certified electrical connector block for dangerous industrial areas that lets you wire two cable levels safely with screw terminals.