Single punch and die set for 40.5mm hole cutting in metal sheets.
Single punch and die set for creating 64mm diameter holes in metal sheets and plates.
Speed punch die combination for cutting ISO 16 standard 16.2mm diameter holes.
Single punch and die set for creating twenty-point-four millimetre holes in metal.
ISO-standard punch and die for larger cable and conduit hole cutting applications.
Standard ISO punch and die set for cable and electrical conduit hole applications.
Single punch and die set for making fifty-millimetre holes in metal sheet materials.
Centre punch with 14mm shank for marking drill points on metal surfaces.
SAM short pin punch with 12mm shank for precision assembly and repair.
Single punch and die set for making 22.5mm holes in electrical conduit and panels.
SAM long pin punch with 12mm shank for deep assembly and fastening work.
Five-piece SAM drift punch set for pin and fastener removal work.
Draw stud component for Greenlee Speed Punch system assembly.
Three-speed controller for T-Series ventilation fans at 220-240V.
Six-piece drift punch set for removing pins from metal assemblies.
Eight-piece drift punch set for pin removal and assembly work.
SAM drift punch 160mm overall length for medium fastener removal work.
Gedore six-piece pin punch set with 10mm shank for general assembly.
Facom drift punch with 5mm shank for removing pins and fasteners.
Eight-piece centre punch set for marking multiple hole positions.
Seven-piece Facom drift punch set for removing pins and assembly work.
Facom drift punch with 4mm shank for small pin and fastener removal.
Facom drift punch 10mm shank for removing larger pins and fasteners.
Seven-piece drift punch set with assorted sizes for varied pin removal and alignment tasks.
Seven pin punches in imperial sizes for assembly and disassembly work.
Eleven-piece pin punch set covering complete range for all pin marking needs.
Single centre punch for marking hole locations on metal surfaces.
Facom centre punch with 3mm shank for precision metal marking work.
Six small pin punches for removing or setting tiny pins in assemblies.
Set of 26 pin punches for driving nails and marking in metalwork.
Five-piece drift punch set for removing pins and aligning holes.
Five-piece pin punch set for removing and aligning small pins.
Five-piece parallel pin punch set for general metalworking and assembly tasks.
Drift punch 150mm long with 4.5mm shank for removing pins from assemblies.
Facom parallel pin punch 1.4mm shank for fine precision metalwork.
Six-piece set of parallel pin punches ranging from 3 to 8mm diameter.
Three-piece centre punch set for marking and locating holes on metal.
Two-speed controller for commercial fans running on 220-240V AC power.
Short pin punch 120mm long with 8mm shank for removing dowel pins.
113-piece engraving punch set with numbers and blanks for metal identification.