Fine-filtration vacuum system filter for protecting suction equipment.
Quick-connect plastic blanking plug for sealing 4mm air tubing.
Ultra-high pressure sensor up to 750 bar for hydraulic and pneumatic applications.
Extended nozzle attachment for blow guns to reach confined or hard-to-access areas.
Low pressure switch rated 1 bar for pneumatic system monitoring and protection.
A magnetic sensor switch that mounts on standard DIN rail and controls electrical circuits when a magnet is nearby.
Multi-material plug fitting to seal 8mm pneumatic tubing connections.
Compact refrigerated dryer removes moisture from compressed air systems.
Round rubber spacer for mechanical assembly and vibration isolation applications.
High-efficiency replacement nozzle for pneumatic blow guns with reduced air consumption.
Compact 9-liter air compressor for powering pneumatic tools in workshops and small industries.
Lightweight plastic pipe cutter for 13mm diameter plastic tubing.
Articulated swinging nozzle accessory for flexible pneumatic blow gun positioning.
Lightweight plastic pipe cutter for cutting plastic tubing and pipes up to 12mm.
Plastic pneumatic silencer reduces compressed air system noise.
Electronic pressure sensor for compressed air systems up to 10 bar.
High pressure sensor monitors systems up to 500 bar for hydraulic and pneumatic applications.
Pre-made one-meter coaxial RF cable with male SMC connectors for signal transmission.
Pressure sensor monitors air or gas systems up to 1 bar with 24V output.
Compact aluminum check valve that allows flow one direction only.
PNP solid state switch for pneumatic rotary actuators and cylinders.
Adjustable pneumatic exhaust valve with silencer for noise reduction.
Ultra-fine replacement filter cartridge for high-efficiency pneumatic air preparation.
Air-cooled dryer removes moisture from compressed air systems efficiently.
Stainless steel pneumatic silencer for corrosive environments.
Electronic chiller removes moisture from compressed air using cooling technology.
Threaded nozzle adapter for blow guns with multi-inlet compatibility.
Portable 140W Peltier-based heat pump for heating and cooling on the go.
Solid state switch for pneumatic cylinders and compact applications.
Brass plug for sealing M5 metric threaded pneumatic ports.
Reed switch sensor for pneumatic cylinders and actuators in factory automation.
Plastic pneumatic silencer reduces compressed air system noise.
Pneumatic exhaust cleaner with built-in silencer for clean air release.
Reed-based auto-switch for pneumatic cylinders with LED status light.