Zinc-plated steel mudguard washer for M12 bolts, protects surfaces in industrial applications.
Large zinc plated sleeve anchor for heavy-duty installation on thick masonry surfaces.
1.5 meter steel metric ruler for accurate marking and measuring on work surfaces.
Black self-adhesive anti-slip plastic floor mat for safe workplace surfaces.
3M sanding disc backing pad for use with ROLOC abrasive discs in surface preparation.
Red banana plug 16A 4mm gold-plated solder connector for test equipment.
Large stainless steel washers for M10 bolts, protecting surfaces in outdoor construction and machinery.
Set of 9 metal number punches 0 to 8 for stamping identification marks on surfaces.
Short grey cable cover joins or terminates cable runs safely on flat surfaces.
Flat compression load cell measuring 30kg for weighing scales and material testing equipment.
Bracket partition accessory for securing 1/2 inch valve taps to walls and surfaces.
Black acrylic-coated duct tape rated to 130°C for repairs on warm surfaces.
Electric sit-to-stand gaming desk with 44-inch surface for esports and office work.
Small surface-mount safety fuse protecting circuits up to 125 milliamps at 125 volts.
Natural polyamide P-clip for securing 28.5mm diameter pipes and cables to surfaces.
Mains-powered phone line tester with BT plug for UK telephone network testing.
Square PVC cable trunking bench unit for 50x50mm cable management on work surfaces.
AC current measurement clamp rated for 240 amps with 3% accuracy for electrical testing.
Single calibrated output high-voltage DC supply for precision electronics and testing work.
Red perforated PVC mat provides drainage and anti-slip surface for wet areas.
Compact nylon cable tie mount bracket for securing small cable bundles to surfaces.
Calibrated device testing wrist and foot straps for proper static protection in electronics production.
Small self-adhesive PVC cable trunking for neat wire concealment on walls and surfaces.
Self-adhesive black tape mount for organizing and securing wide cable ties on surfaces.
Ultra-fine silicon carbide sanding disc for precision surface finishing and polishing work.
Black stainless steel pipe clip for securing 22mm diameter pipes and tubes to surfaces.
Surface-mount ceramic fuse 3A 125V for circuit board protection and overcurrent control.
AC/DC bench power source for laboratory testing with 500VA capacity and dual voltage.
High-power 1.2kW programmable bench supply up to 60V and 50A for industrial testing.
Latex-coated gloves with grip palm surface for quarrying, fishing and sharp material handling.
Compact force gauge for basic material strength testing with 50 Newton measurement range.
Small metric thread plug gauge for testing M3 threads and bolt hole specs.
Bulk pack of 100 natural screw-fixed mounts for securing cable ties to surfaces.
Tiny surface-mount safety fuse for protecting low-voltage electronic circuits and equipment.
Ultra-precision force and torque gauge with RS232/USB output for demanding laboratory testing.
Coarse zirconia sanding discs for rapid material removal on wood, metal and composite surfaces.
Tiny surface-mount fuse for protecting 24V circuits in industrial electronics and control boards.
Two carbon steel drill brushes for Dremel rotary tools, for cleaning and surface prep.
Premium silicon carbide sanding disc for ultra-fine finishing work on metal surfaces.
Large 910mm box level for checking level on building walls and long construction surfaces.