Ultra-compact 1A electronic breaker for 24V precision circuit protection.
Crocodile clips for connecting test equipment to electrical circuits during measurement and diagnostics.
Black terminal post with 1.6mm hole for test equipment connections.
Red 2mm-to-4mm test adapter with gold plating for equipment interconnection.
A small 4-position slide switch that mounts directly on circuit boards for configuring equipment settings.
66-piece electronics technician's toolkit for circuit board and device repair work.
Smoke pump for air tightness testing, pressure range -200 to +200 mbar.
Compact crocodile-clip test lead for safe low-current electrical measurements.
Colored banana test cables for multimeters rated 1000V with silicone insulation.
Blue 1m test leads with banana connectors for safe electrical measurement.
Testing labels for Seaward Apollo+ series PAT testers for equipment certification.
Portable RCD and earth loop impedance tester for electrical circuit safety and compliance verification.
Specialist adapter for PAT testing of welding equipment.
Safety-rated test lead kit for multimeters, 1.2m length, 10A capacity.
A 10-position DIP switch that mounts directly onto circuit boards to configure electronic equipment settings.
Adapter accessory for Gossen Metrawatt SECUTEST S II PAT testing equipment.
Short blue test lead 250mm, 1000V 10A rated with silicone insulation.
Short silicone test lead with banana plugs, 250mm length, rated 10A at 1000V.
10-amp rated test lead for electrical multimeter measurements up to 1.2 metres.
This is an electronic control unit that powers TL5 fluorescent tubes using 220-240V electricity.
Durable industrial test leads for multimeter and measurement tool connections.
Powered electronic medical cart for clinical equipment and device transport.
Benchtop PAT tester with flash test capability for comprehensive electrical safety.
Red failure labels mark equipment that did not pass electrical safety testing.
Test probe with 2.5mm tip rated for 1kV electrical measurements.
Osram 80 W electronic ballast powers one T5 fluorescent light tube on 240 V electricity.
120mm ESD-safe flat-tip pliers for electronics assembly and component handling.
Test probe lead with 20A rating and ABS insulation, 1.2m length.
Black PVC insulator boot that covers test clips for safety and electrical protection.
Test lead kit with multiple connector sizes, CAT II 1000V rated.
Red PVC insulator boot covering test clips for safety and electrical protection.
Replacement test cable accessory for Chauvin Arnoux CA 6155 multifunction tester.
Purple 1.5-meter test lead rated 1000V 10A with silicone insulation.
Green 1.5-meter test lead rated 1000V 10A with silicone insulation.