Pre-made BNC to crocodile clip test lead for laboratory and field electrical measurements.
Rack-mounted 5kW resistive load bank for testing and commissioning electrical power systems.
Digital bench oscilloscope with 2 channels and 100MHz bandwidth for electronic signal testing.
A 10-position surface-mounted electrical switch for PCBs that lets you set device configurations, commonly used in industrial control and electronics equipment.
Black PVC insulation cover for test clip probes providing electrical safety.
Black PVC insulation boot for test clip probes providing electrical safety.
Short CAT II test lead with 4mm safety plug, 19A rated for precise electrical measurements.
-SMA(m)&sirasi=0)
600mm RF test lead connecting PicoVNA network analysers for signal measurement up to 8.5GHz.
A 6-position surface-mounted electronic switch that lets you configure settings on circuit boards by sliding individual switches on or off.
Stauff high-pressure hydraulic test point rated 630 bar for system diagnostics.
Red PVC insulation boot for test clip probes providing electrical safety protection.
Multimode fiber launch cable for OptiFiber Pro network testing equipment.
A red mushroom-shaped emergency stop button that mounts on surfaces and stops machinery instantly when twisted; used on factory equipment and control panels.
Black grabber clip with right angle jaws for electrical testing and measurement applications.
Black PVC insulator cover for protecting test clip contacts.
White PVC insulator cover for test clip electrical safety.
Blue PVC insulator cover for test clip safety protection.
A 10-position surface-mounted DIP switch with rocker buttons for configuring electronic equipment and control systems.
White surface-mounted network outlet box for wall installation.
Black binding post 16A 30-60V connector for electrical test and measurement.
Mechanical surface gauge for layout and inspection work on flat surfaces and edges.
Red PVC insulating boot protects test clip connections from electrical hazards.
Red PVC insulating boot protects test clip connections from electrical hazards.
Red PVC insulating boot protects test clip connections from electrical hazards.
Blue binding post rated for 63 amps, used in high-current electrical testing.
Programmable DC electronic load for testing power supplies and batteries up to 500V.
Red grabber clip with pincers for low-current precision testing and electronics work.
Blue needle test probe for high-voltage circuits rated 1kV and 3 amperes.
Surface-mounted power outlet box for institutional and office electrical wiring.
High-safety insulated test lead set for electrical measurement at 1.5 meters length.
A red mushroom emergency stop button with twist-release that mounts on surfaces and works in wet, dusty, or high-pressure wash environments on machines and industrial equipment.
Insulated 1.5-meter test lead set with 4mm connectors, CAT IV safety rated.
2-port white surface mount box for wall-mounted network connections.
Weather-resistant outdoor dome light that mounts directly on walls and surfaces, using just 12 watts and supplied ready to install.
Advanced software for managing and recording portable appliance safety test results and compliance.
Low-voltage 4.5V DC surface-mount relay for dense electronic assemblies.
Electrical insulation resistance tester for testing cable and equipment safety compliance.
Professional electrical tester with automatic RCD testing for installation safety verification.
Two-channel digital oscilloscope for laboratory electronics testing and signal measurement.
Four-channel 100MHz bench oscilloscope for testing and diagnosing electrical circuits and equipment.