Black binding post connector for 35 amp testing and measurement applications.
Wireless clamp meter measures electrical current and voltage up to 600 amps.
Four-pole 125-amp circuit breaker with leakage current protection for electrical panels and networks.
Three phase current monitoring relay for industrial circuit protection and control.
Three phase current monitoring relay for industrial equipment protection and control.
Black test connector adapter with brass nickel-plated contacts for 4mm sockets.
Three phase current monitoring relay mounted on DIN rail for system protection.
Blue hook clip for electrical testing equipment, rated 20A at 1kV with 4mm socket.
Fused test probe accessory for safe electrical circuit measurement and testing.
Adhesive labels for electrical safety testing certification.
High-current monitoring relay for overcurrent and undercurrent detection up to 200A.
Precision pulse generator for testing electronic circuits and signals up to 50 MHz.
Professional electrical safety tester for circuit testing and RCD compliance verification.
Safety relay that cuts power if dangerous leakage current is detected in electrical circuits.
Isolates current signals and outputs both current and voltage for flexible control.
HARWIN test pin component rated for 3 amperes in test and measurement applications.
Three phase current monitoring relay for industrial equipment protection on DIN rail.
Three phase current monitoring relay mounted on DIN rail for circuit protection.
Test connector adapter with 4mm socket and nickel-plated brass contacts for measurements.
High voltage test lead set for insulation testers CA 6550 and CA 6555 models.
Dual AC/DC clamp meter for measuring electrical current and voltage up to 600A.
Clamp meter for measuring electrical current, voltage and resistance up to 400A safely.
3A test pin with needle probe tip for electrical measurement and testing.
Portable AC current clamp measuring up to 600 amps for electrical circuit testing.
Pre-printed adhesive labels marking electrical safety testing compliance on equipment.
Digital clamp meter measuring high AC and DC currents up to 1500A.
Three phase current monitoring relay for detecting overcurrent and undercurrent conditions.
ATEX-certified signal conditioner converts and isolates current signals for hazardous industrial environments.
Single phase current monitoring relay with double pole contacts for industrial protection.
Compact AC/DC clamp meter up to 400A with UKAS certification for accurate field testing.
Black and red test connector adapter with 4mm socket and nickel-plated brass contacts.
Multi-category insulated test leads rated CAT II, III, IV up to 1500V.
High-voltage test leads for insulation testers used in electrical safety checks.
Large tie-on labels for electrical safety testing compliance.