Fused test probe accessory for safe electrical circuit measurement and testing.

Adhesive labels for electrical safety testing certification.

Yellow narrow test probe rated 1kV and 16 amperes for CAT IV measurements.

Precision pulse generator for testing electronic circuits and signals up to 50 MHz.

Professional electrical safety tester for circuit testing and RCD compliance verification.

HARWIN test pin component rated for 3 amperes in test and measurement applications.

Test connector adapter with 4mm socket and nickel-plated brass contacts for measurements.

High voltage test lead set for insulation testers CA 6550 and CA 6555 models.

3A test pin with needle probe tip for electrical measurement and testing.

Dual-function generator and frequency counter for lab testing and calibration.

Pre-printed adhesive labels marking electrical safety testing compliance on equipment.

Multi-function tester for socket, loop impedance and RCD circuit checks.

Multi-category insulated test leads rated CAT II, III, IV up to 1500V.

Black and red test connector adapter with 4mm socket and nickel-plated brass contacts.

High-voltage test leads for insulation testers used in electrical safety checks.

Large tie-on labels for electrical safety testing compliance.

Stauff hydraulic test point connector rated 400 bar for system pressure measurement.

Test lead and connector kit for Megger test and measurement equipment.

Specialized testing cable for fiber optic network measurement and certification.

Pomona comprehensive test lead kit with red and black connectors, pins, sockets and leads.

Safety-rated test probe with 4mm connector for electrical measurement and testing.

Optical light source meter for fiber optic cable testing and telecommunications network verification.

Professional function generator producing complex waveforms up to 20MHz for electronics testing.

Three-amp test pin connector for electrical circuit testing and measurement.

Function generator with FM modulation and network connectivity for laboratory signal testing to 25MHz.

Test probe rated CAT IV 600V for safe high-voltage electrical testing.

Test pin rated 3 amps with 17.4mm probe socket for electrical test connections.

Portable intrinsically safe calibrator for measuring voltage and current in hazardous industrial areas.

10A test probe for circuit testing with wide operating temperature range of minus 20 to 70 degrees.

Spring-loaded test probe with serrated tip for circuit testing and measurement.

Small red brass test clip for attaching to electrical test points.

Short CAT II rated test probes for general electrical circuit testing and measurement.

High-speed network test system for 400G PAM4 connectivity testing.

Safety-rated test lead with connectors for multimeter electrical testing.

Test adapter for R2Check electrical testing equipment.

Test adapter for electric vehicle charger installation testing and verification.

Earth loop impedance and RCD tester for electrical system safety verification.

Compact five-megahertz function generator with variable sweep for basic signal testing.

Short brown test leads for electrical measurements and circuit testing.

Black Mueller Electric test probe rated 30V for low-voltage electrical testing.