A tool that lets you safely test electrical connections on DIN rail terminal blocks without unplugging wires.
A brown test terminal block that clips onto DIN rail for safely connecting and disconnecting wires during electrical testing and maintenance.
Test accessory for Lovato push button switch contact elements in control panels.
Testing connecting lead wire for electrical measurement and potential equalization applications.
A wireless test switch for emergency lights that doesn't need batteries, used to check that emergency lighting systems work properly.
PAT testing labels for safety compliance documentation and equipment tagging.
PAT testing labels for safety compliance documentation and equipment tagging.
Smart 12-volt car battery charger with built-in battery testing capability and UK connection.
A simple switch that lets you test your building's emergency lights to make sure they work when needed.
Staubli test lead wire for electrical connections and potential equalization in industrial settings.
A compact kit that converts your existing ceiling lights into emergency backup lights that automatically test themselves.
Test function auxiliary switch module for Siemens SENTRON disconnectors.
Automatic reset temperature switch for heating systems rated to 100 degrees.
Grey electrical connector block that screws onto DIN rail, used to safely disconnect and test circuits in industrial control panels.
Dual contact automatic reset thermostat for heating systems up to 130 degrees.
Dual contact automatic reset temperature switch for heating systems to 150 degrees.
Single-phase automatic circuit breaker for protecting motors and inductive electrical equipment.
Single-phase automatic circuit breaker protecting electrical circuits from overload and short-circuit damage.
Dual contact automatic reset temperature switch for heating systems to 100 degrees.
Eaton push button test element for electrical control panels, rated 12-240V.
A grey electrical connector block that screws onto DIN rails, designed for safely testing and disconnecting circuits in control panels.
Flexible red silicone-insulated hook up wire for electrical testing and equipment connections.
Honeywell automatic temperature switch for heat detection and equipment protection.
Pre-made BNC to crocodile clip test lead for laboratory and field electrical measurements.
Heavy-duty three-phase automatic power switch for industrial motor and load protection.
Automatic temperature switch that opens at 90°C and closes at 75°C for equipment protection.
Three-phase automatic circuit breaker rated 125A for motor and transformer protection.
Three-phase Type B automatic breaker for lighting and socket circuit protection.
Three-phase automatic breaker 32A for motor and transformer protection in industrial settings.
Three-phase automatic breaker 50A protects electrical installation from overload and short circuits.
Type B automatic breaker 63A for lighting and socket circuits in buildings.
Type B automatic breaker 16A for lighting and socket circuits in residential applications.
High-capacity three-phase automatic breaker 32A with 10kA rating for industrial motors.
Single-pole automatic circuit breaker for electrical protection and switching in low-voltage systems.
An automatic light switch that turns outdoor lights on when it gets dark and off when the sun rises, saving energy.
Three-phase automatic breaker rated 10A for industrial and residential inductive load protection.
A square LED emergency exit light that automatically tests itself and works even when power goes out, suitable for marking safety exits in any building.
Flexible silicone test lead for electrical testing and measurement connections.
A grey screw-type connector block for safely wiring electrical cables in industrial control cabinets and panels.
Industrial brown terminal block for connecting wires inside electrical panels, rated for 10 amps at 400 volts with a simple screw tightening method.