Rittal draw stud hardware component for electrical enclosure assembly and fastening.

Draw stud component for punching holes in sheet materials.

Draw stud accessory for hydraulic punch systems on sheet metal.

Draw stud hardware component for enclosure assembly and installation.

Draw stud hardware component for enclosure assembly and installation.

Drift punch for drifting out pins and bushings from mechanical components.

Single compact drift punch for separating and aligning precision components.

Small drift punch for removing pins from metal components and assemblies.

General-purpose punch for standard metalworking and component assembly operations.

Extended pin punch for reaching deep components during assembly and disassembly.

Longer drift punch for removing pins and aligning metal components.

Fine long pin punch for marking deeply positioned components in assemblies.

Precision drift punch for delicate metalworking and small component alignment tasks.

Short pin punch for removing pins from metal assemblies and machinery components.

Five-piece parallel pin punch set for assembly and alignment of machinery components.

Combined letter and number punch set for stamping identification codes on metal components.

Three-metre steel tape measure 16mm wide with two-component design.

Large steel letter and number punch set for marking identification on metal components.

Two-meter steel tape measure with two-component design for portable measurements.

Compact short pin punch for precise work on small mechanical components and assemblies.

Handheld punch tool for creating 25-millimetre circular holes in metal components.

Draw stud component for punch and die tool kits used in metalworking assembly.

Single parallel pin punch with 3mm shank for manual hole alignment and component removal.

Heavy-duty steel 8-meter tape measure with dual components for construction use.